Depending on the year of the Fiesta. From 96 to 02 is under the bonnet; 02 onwards is by the passenger sit. 02 onwards: In the passenger footwell, remove the screw that retains the side facia panel against the centre consule, then remove the panel. Behind this panel is the filter housing. Remove the screws that retain the vertical rectangular cover on the filter housing. Remove the old filter from the housing. Insert the new filter into the housing. Refit the access cover and the facia panel. 96 to 02: Open the bonnet. At the base of the windscreen on the passenger side is a plastic housing under the slotted area of the bodywork strip that holds the wipers. If required for access to the housing, remove the soft rubber clip on profile that runs along the top of the rear of the engine bay bulk head. Unclip and pivot down the tabs on the housing. This will enable the access door to open upwards. Take the old filter out. Insert the new filter. Close the access door on the housing, clip the tabs on. If previously removed refit the rubber trip to the bulkhead.
Copyright © 2026 eLLeNow.com All Rights Reserved.