What is the procedure to remove the window motor on a 1995 z28?

.Before this is started you need to know that you will need a large pop rivet gun to complete installation. REMOVAL. With the window in the up position, remove door trim panel and plastic water shield. Secure the glass in the half way up position with door stops wedged in between the window and door.Do not proceed til you are sure the weight of the glass is supported.Remove the rear guide channel nuts and and take the assembly out of the opening. Punch or drill out the center pinsof the rivets that secure the window regulator in place.Unplug the electrical connector. Move the regulator until it is disengaged from the guide channel and lift through the acces hole. If replacing the window motor, make sure to place a screw in the slot to lock the regulator before separating the motor from the regulator to prevent the spring from unwinding and causing injury. INSTALLATION. Place the regulator in position in the door and engage to the guide channel assembly. Secure the regulator to the door using 3/16 inch manuel aor 1/4 inch power rivots and the rivet tool. Plug in the electrical connector Tighten the channel nuts securely. Install the door trim panel