How do you wire a Catalina Lighting Model 4052 security light?

The following explanation includes references to a couple diagram figures. It does not appear that I can insert the figures in JPEG format, so you will have to make the best of it. This is from the "User's Manual" that came with the fixture. ELECTRICAL CONNECTIONS 1. BE SURE POWER IS OFF BEFORE BEGINNING ANY ELECTRICAL WIRING 2. The fixture is intended to be mounted to a 2" by 4" outdoor outlet box. This box must be supported by the building structure and mounted under a partially protected location such as canopies, roofed open porches and the like, to avoid direct exposure to rain. 3. Refer to the diagram shown in Fig. 2 and the wiring diagram shown in Fig. 3 for electrical connections. Follow this step-by-step procedure for wiring the fixture. Wiring the unit incorrectly may damage the electronic components inside the control module and will void all warranty claims. a. Connect either one of the white wires from the control module to the white wires of the bulb sockets using wire nuts provided with the unit. Be sure no loose strands of wire are present. Secure wire connectors to wires using electrical tape. b. Connect the red wire from the control module to the black wires of the bulb sockets. c. Connect the remaining white wire from the control module to the white wire from the supply circuit. Connect the black wire from the control module to the black wire of the supply circuit. d. Spread the splices in the outlet box so the black wires are on one side of the box and the white wires are on the other side of the box. Mount the assembled unit to the outlet box using two screws. Install the two round gaskets in bulb holders. Install light bulbs into the bulb holders. Do not exceed 500 watts total (250 for each bulb holder, maximum). Flood lights are recommended. Do not connect this unit to sirens, burglar alarms or other devices. The control module is only designed to control incandescent loads of 500 watts total or less. Restore electrical power and follow steps for "Setup."