How do I properly load the line on a Ryobi 40V string trimmer?

To properly load the line on a Ryobi 40V string trimmer, follow these steps:

1. Turn off the trimmer and disconnect the power source.
2. Remove the spool cover by pressing the tabs on the sides and pulling it off.
3. Take out the spool and clean any debris or old line.
4. Cut a length of new trimmer line (about 15 feet) and insert one end into the anchor hole on the spool.
5. Wind the line evenly and tightly in the direction indicated on the spool.
6. Leave a few inches of line unwound and insert the other end into the retainer slot.
7. Reassemble the spool and cover, then reconnect the power source.

Make sure to consult the trimmer's manual for specific instructions and safety precautions.