Replacing the clutch pressure plate and throw out bearing on a Chevy Metro is a relatively straightforward process. You will need a few basic tools such as a set of sockets and a ratchet a torque wrench and a clutch alignment tool. Here is a step-by-step guide to help you replace the clutch components on your Metro:
- Start by disconnecting the negative battery cable to prevent any electrical shocks.
- Disengage the transmission and remove the driveshaft. This is done by removing the bolts located on the front and rear of the transmission.
- Remove the bell housing bolts and the starter. Next lower the transmission and place it aside.
- Remove the pressure plate and the throw out bearing. This is done by removing the bolts that hold the pressure plate to the flywheel.
- Install the new throw out bearing on the transmission input shaft. Make sure to align the bearing with the splines on the shaft.
- Install the new pressure plate on the flywheel and tighten the bolts to the correct torque specification. This should be done in a crisscross pattern.
- Reinstall the transmission driveshaft and starter. Make sure to torque the bell housing bolts to the correct specification.
- Once the transmission is installed reattach the negative battery cable.
Once this process is complete you will have successfully replaced the clutch pressure plate and throw out bearing on your Chevy Metro.
