How do you wire breaker box to earth ground rod?

ITS NOT TO COMPLICATED REALY, YOU NEED A HOLE BIG ENOUGH FOR GROUND WIRE GOING OUT TO PASS THROUGH THE BOX, IF IT IS FOR A BREAKER PANEL IT SHOULD HAVE AN ADAPTER THAT HAS THE INSERT THROUGH THE BOX WITH A LOCKING NUT AND A BUSHING ( PLASTIC ) THAT KEEPS THE CABLE FROM GETTING DAMAGED FROM COMING IN CONTACT WITH METAL BOX. THERE SHOULB BE A GROUNDING BUSS IN THE BOTTOM OR ONE OF THE SIDES THAT HAS THE ATTACHMENTS FOR THE GROUNDS FROM 1 TO WHO NOWS HOW MANY DEPENDING ON HOW MANY GROUNDS YOU WILL NEED.( ONE BIGGER GROUND WIRE COMING IN TO BUSS BAR, SEVERAL( DEPENDING) SMALLER WIRES COMING FORM THE FEEDS THROUGHOUT THE STRUCTURE. )ONCE YOU GET BUSS AND INCOMING GROUNDS, THE ONE THAT ATTACHES TO THE GROUND ROD AND THE WIRE ( BE SURE TO PUT THE ACCORN CLAMP ON BEFORE YOU PUT THE GROUND ROD INTO THE GROUND , IN CASE IT GETS MUSHROOMED DOWN FROM DRIVING IT INTO THE GROUND) USE WATER IN THE HOLE , RAISE THE GD. ROD UP AND DOWN KEEPING THE HOLE FAIRLY WET . IF IT IS JUST DIRT IT WILL GO IN REAL EASY, IF THERE IS ROCKS AND ETC. IN HOLE YOU WILL HAVE TO DRIVE IT IN. THE FURTHER GROUND ROD GOES IN THE BETTER. 10 FEET IS THE COMMON LENGTH FOR THE ROD TO GO INTO THE DIRT .ATTACH THE WIRE TO THE ROD WITH THE CLAMP YOU PUT ON PRIOR TOO AND YOU HAVE GOT IT.