How do you change the starter for a 1996 Oldsmobile achieva?

All except 2.3L and 2.4L (Quad -4) models

CAUTION: If it has the Delco LocII audio syatem, make sure you have the correct activation code before disconnecting the battery. 1) Disconnect the negative battery cable 2) Raise the vehicle and support on jackstands 3) Under the vehicle disconnect the solenoid wire and battery cable from the stater solenoid. 4) Remove the starter motor bolts 5) Remove the starter motor NOTE: the location of spacer shim(s) 6) Installation is the reverse of removal NOTE: Be sure to install the shim(s) in the same location

2.3L and 2.4L (Quad-4)

See CAUTION ABOVE

1) Disconnect the negative battery cable 2) Remove the intake air duct 3) Remove the cooling fan 4) Remove the oil filter 5) Remove the starter mounting bolts and pull the starter out enough to disconnect the battery cable and wiring harness from the solenoid 6) Lift the starter out between the intake manifold and radiator 7) Installation is in the reverse of removal

Edit: I just did this in my 97 4cyl and I just wanted to add to these instructions that you may have to unscrew the starter relay to get the cooling fan out. The starter relay is right next to the battery. Also, check the wires coming out of the starter relay. There is a purple wire that connects to a connector mounted above the oil filter. It's easy to accidentally unplug when you are installing the new starter, make sure you get it back in there or the car won't start.