How do you bleed the air out of a Honda Accord cooling system?

This is one of the simplest jobs you can do on an Accord. You will need a 10mm box-end wrench and a jug of Honda Genuine coolant - accept no substitutes.

Turn your heater controls to the full-on setting and pop the hood. Find the upper radiator hose and trace it back to the engine. On the place where it goes in (the thermostat housing) you will find a bleeder nipple. Take the radiator cap off, open the nipple and start pouring coolant into the radiator until a steady stream of fluid comes out of the nipple. Then close it quick, make sure the radiator is full, and put the radiator cap back on.