th the back seats up and locked do the following;
1z0 reach your fingers back behind the cushion where the back of the seat meets the bottom on one side or the other, it doesnt matter. pull it up till it feels like its bending. it will stay in place.
2) repeat the same procedure on the other side then stop do the other side. only till it bends. stop. the middle section between the 2 seat belts is still flat and appears to be in place.
3)now pull up the middle section grasping the outer most parts of the center cushion firmly. you will hear the rear mounts pop loose and the seat will rise immediately. dont pull it up more than a few inches. let it rest slightly elevated. stop
4)now move the front seats as far forward as possible, youll need all the room. kneeling in front of each corner, slide your fingers in under the seat as far as you can and still get a grip, and pull upward, fast and HARD. it will pop up quick, just like the rear outside ends did. do the same anon the other end and gusto its ready to pull out. pull forward and lift up at the same time. it is now out. it looks and seems like you are bending thee seat and doing damage. but there is no frame in the lower cushion at all. it weighs about fifteen pounds and straightens right out when you lay it down on the floor.
5) reverse to install. you will feel it pop back in as you push down at each point you pull at earlier. total time 1rst attempt 8 minutes. second ttime 45 seconds (out and back
look at the mounting point before you reinstall and you will see clearly how it works.
good luck and pull hard!
Copyright © 2026 eLLeNow.com All Rights Reserved.