Audi A4 1996 front bumper removal?

1. Look at your wheel well, remove all screws and the two plastic pin-screws from the about 5cm x 25cm plastic peace in the wheel well (quite visible). do this on both sides. Then remove the lower front grille (rip it out after removing two small screws going horizontally inwards from about the middle). After that, remove the two bolts holding down the airbag sensor tubes. these are located behind the lower front grille. Then use a screwdriver to bend the upper corners outwards while pulling the bumper forwards. Repeat on the other side. This has been tested on a 1995mod A4. I cannot guarantee that its the same on the 1996.