Ten Peaks Tents are supported by Northpole USA. Instruction manuals can be downloaded at www.northpoleltd.com/manual. If you are in need of a product manual prior to 2006, or do not see your manual listed, you can request a copy to be sent to you via e-mail at consumer@northpoleusa.com. Please list your model number in your request and allow 48 hours for a response.
CAN'T FIND YOUR MODEL NUMBER? Places to look: inside your tent, attached to pocket, on a label inside carry bag or underside of fabric cover, and lastly, on parts page in your original owner manual.
Be advised my Ten Peaks Tent model SAMT-1412 is different than the instructions submitted below. I recommend getting the pdf instructions from NorthpoleUSA customer service. If your model is no longer being produced and parts are no longer available Customer Service will send you links for aftermarket poles and repair for fabric.
Here are the assembly instructions to the best of my knowledge.
Ten Peaks Tent by Quest
1) Lay out the tent flat on the ground, be sure to stretch floor to eliminate slack. Drive a stake into each corner loop, then drive the remaining stakes into the side loops.
2) Install the poles by first separating them by their color code. Yellow poles make up the center section. Red poles make up the right and left sides. Slide the yellow poles through the center pole sleeve. Slide the red roof poles through the right and left pole loops of the tent.
3) Raise the tent. Assemble the yellow upright poles and attach them to the yellow roof poles. Raise the center of the tent to its approximate height, by using the quick clamps on the bottom of the yellow center uprights. Assemble the red left and right support poles, attach the support poles to the roof poles. Place the side support poles on the ground near the side stake loops. Adjust the placement and the height of the poles until the tent stands firm.
I hope the helps anyone with this tent model. Good luck and great camping!
Copyright © 2026 eLLeNow.com All Rights Reserved.
