How can you remove the impeller from a Hayward Powerflow pump shaft?

I have a Powerflow II. To remove the impeller, first remove the housing cover. There are about six botls holding this on. You then need to remove the motor housing cover from the other end. There are three small screws holding this on.

With the motor cover off you can see the other end of the shaft. You mayhave to remove or at least loosen some things on the end of the shaft to get a wrench on it. The shaft is flattened on two sides and it should take a 7/16" (I think that is the right size)wrench. Use that to hold the shaft and then unscrew the impeller by hand.

It should unscrew the conventional way (anti-clockwise). COUNTER-CLOCKWISE

I am guessing you want to replace the seal. Don't make the same mistake I just did. I got the two pieces reversed and it nearly melted my impeller shaft. Talk about a pain. Now I need a new seal and a new impleller.

Its dead easy if you get it right. Good luck.

The black grafite and the white ceramic parts of the seal touch