How to Reset belt on kawasaki brute force 750?

When the light comes on it is your atv's way of telling you that the belt needs to be checked and probably adjusted. Take it back to your dealer and have them check and adjust the belt and they will automaticly reset your light. the reset procedure is similar to 650 700. Unplug 2 pin conector going to belt switch. Unplug black conector under seat , unplug white conector beside it ( white plug is a reset plug which has no wires conected to it from machine) Plug reset plug into black plug turn key to on , turn off. plug everything back to stock. You are done."

1) remove seat, unplug black and grey 4-pin connectors

2) swap plugs, grey to black and black to grey

3) turn on ignition switch, belt light should be flashing quickly

4) disconnect 2-pin belt switch above torque converter cover, belt light should be flashing slowly

5) let flash for at least 5 seconds

6) turn off ignition switch

7) reconnect 4-pin connectors black to black and grey to grey, reconnect 2-pin belt switch

turn on ignition switch to confirm belt light is out this answer is wrong disconect 2 wire switch on cover only connect grey male to blk female then switch on