How do you bleed the fuel lines on a diesel Mitsubishi pajero?

When you install the other filter under the hood dont screw it on all the way leave it loose so the air can escape the lines

Turn the keys to on position then spiral thing pops up tells you to wait for spark plugs to warm up at the same time it primes the fuel lines too so turn it on wait till light go off, turn off the key and do it again about 5-12 times it can be as long as 2 trys if you did every thing perfectly and you will see or hear the diesel pooring out of the fuel filter under the hood.

4th Tighten the filter

5th turn key to on wait for light to go off and start while pumping gas pedal should start right up.

Very good question and have fun on your project.

best way i know how is to open one of the injector lines a little and turn the engine over till fuel comes out

Realistically, I have owned a 7.3 turbo for 15 years and replaced many fuel filters in many diesels. It has never been necessary to bleed the fuel system.

柴油三菱帕杰罗的燃油管路放油过程如下： 1. 首先，确保发动机已经冷却，防止烫伤。 2. 找到柴油滤清器下方的放油塞，通常这个放油塞会有一个箭头指向油箱方向。 3. 准备一个合适的容器来接放出来的燃油，这个容器最好是金属的，并且能够密封。 4. 拆卸放油塞。在拆卸前，您可能需要松开周围的固定螺丝，以便放油塞顺利旋转。 5. 让燃油自然流出，直到流速变慢或完全停止。注意观察，避免燃油溢出。 6. 重新安装放油塞，并确保它拧紧。如果有必要，可以涂抹一些密封胶来确保密封。 7. 检查是否有燃油泄漏。启动发动机，观察是否有燃油从放油塞处泄漏出来。如果没有泄漏，您可以启动车辆并进行一些行驶测试，以确保燃油系统正常运行。 请注意，在进行任何维护工作之前，建议您查阅车辆的维修手册，以确保您按照正确的步骤操作，并避免损坏车辆的其他部件。