Changing turn signal bulb on a Taurus?

Hey where are the screws ... Right ! The entire lense assembly must first be removed and then it's just twist-n-turn and pop in a new bulb. To remove the assembly first remove the upholstery panel that runs from tailight to tailight inside the trunk. To do this remove the two plastic mushroom looking things on the panel. They have a place for a torx screwdriver but you can probably use a similar size hex wrench or even pliers since they did not seem to be too tight. The trunk light is on this panel so you you may want to disconnect the trunk light (or temporarily tape over the bare contacts) so you don't get a sparking surprise if you contact it with a wrench. Now you can see the nuts that hold in the tailight assembly ... remove all the nuts and carefully pull the taillight assembly away from the car body. If it is stuck, (and it probably will be), gently tap on the studs that the nuts were on with a rubber mallet (or use a regular hammer and a small block of wood to protect the studs). Don't hit the black plastic locator pins if you can help it. Keep tapping on the studs one-by-one and the assembly should release. Now that its out you will see a twist-n-turn connector with some wires hanging out of it. So just twist, turn, pull it out , replace the burned out bulb and reverse the entire procedure, There now wasn't that easy!