How do you remove the passenger front door panel on a Mitsubishi endeavor?

1. Turn off the Battery power by disconnecting the negative pole of the battery

2. Be sure the glass of the door is on the up position to prevent breakage

3. Remove the 2 screws on the handle of the door panel

4. Remove 1 screw behind the handle on the lock latch

5. Remove the plastic cover on the latch using a screw driver wrapped with a rag to prevent damage to the plastic. Start working anteriorly (front of vehicle) to posterior. Try to insert a small screw driver to release the "clip lock" of the cover which is found near the hinge of the latch. Be very careful not to break this plastic cover. For me this is the hardest part to do.

6. Pry out the cover of the door light with a screw driver wrapped with a rag. Remove the bulb and remove the small screw and detach the light housing from the connector.

7. Pry upward the whole housing unit where the controls of the mirror, door lock etc. from the door panel handle (this is secured only by clips). You can use your fingers to do this but you can use the protected screw driver as well. Disconnect the connectors

8. Now, you are ready to detach the whole door panel. The plastic door panel is attached to the door by several clips. Look under the door and you will see two small rectangular notches on the panel. Try to insert a protected screw driver thru it and try to pry out and dis-engage the clips that hold the door panel. There are several of these. Try to sweep the screw driver in to locate the other clips.