The fuse panel is located below and to the left of the steering wheel by
the brake pedal. Remove the panel cover to access the fuses. To remove
the fuse panel cover, pull up on the latch on the top left side of the
cover.
To remove a fuse use the fuse puller tool provided on the fuse panel
cover.
The fuse holder is designed to allow you to pull the fuse (#6) from the
fuse panel circuit without having to completely remove it from the fuse
panel. The fuse and fuse holder will remain in the fuse panel.
If the fuse (#6) must be replaced, the fuse and fuse holder can be
removed by pulling it completely out from the fuse panel cover.
With the fuse (#6) removed, the following systems will not be functional:
• radio
• power sliding door(s) – (if equipped)
• keyless entry system– (if equipped)
When the pull fuse is reinstalled, the following features will need to be
reset.
• radio pre-sets
• power sliding door(s) – (if equipped)
Please refer to the Entertainment chapter and Power Sliding Door
section in the Driver controls chapter for instructions to reset these
features.
I copied this from an owner's manual for a 2003 Ford Windstar. Hope it helps:)
Copyright © 2026 eLLeNow.com All Rights Reserved.