How do you install ignition switch on a Yamaha motorcycle?

The ignition switch is riveted in place on many older motorcycles. If you don't own a riveting tool then you can fasten it with two small bolts and nuts. The wiring is easily reconnected as the proper connectors come with the new switch. If not, you have to figure out how to connect the wires to the switch by soldering them in place. You need the service manual for this. In general, the colors of the wires are the following: The black wire is the 12 volt power wire, the brown is the running lights, the yellow is the left turn signal and stop light, the green wire is the right turn signal and stop light, the white is the ground wire attached to the bike's frame. Blue is for the brake light.