You cant get the clutch bled after you replaced the slave cylinder on a 1994 ranger it wont bled still has air in it?

this can be a problem,first you have to press the pedal about an inch do this several times,wait about an hour do it again.....if this doesn't work,it has to be power bled. you transmission shop can do it for you..... I had the same problem. The problem is the cylinder slants down toward the front and that is where the reservior and line connect. There is no good way to get all the air out while mounted to the firewall. Solution: unbolt from firewall with lines and reservoir attached. Tip the cylinder up in the front and use a vacuum bleeder at the slave cylinder.