How do you replace your seat belt on a 99 Ford Explorer?

'96 Explorer Seat Belt Replacement

http://www.seatcoverset.com/seatcovers-car_seat_cover.htm

In order to replace the driver side seat belt on a '96 Explorer, you must completely remove the drivers seat. Removing driver side seat belt: Use a 10mm socket/wrench to remove the two bolts securing the front of the seat to the floor. Move the seat as close to the steering wheel as possible to expose the rear of the sliding seat rails. Pop off the two covers at the end of each rail to expose two more 10mm bolts securing the seat to the floor. Next, remove the plastic cover with a Torx symbol on it at the rear of the seat belt guide rail. Removing the aforementioned cover will allow access to a large Torx bolt just below the rear of the center console. Remove this large Torx bolt, unplug any electrical wires below the seat, and remove the entire seat from the Explorer. With the seat out, you can use the same Torx wrench to unscrew the seat belt itself from the seat. Reassembly is the opposite of disassembly.