How do you use a super flame oil heater?

super flame oil heater is quite simple to operate. First open the cover and make sure the internal burning area is free from debris..on the right hand side towards the top is a knob that will allow the flow of fuel oil into the burning area. Turn this valve to medium.....use a paper towel and wad it up, lite it and place into the burning area....(you should see a wet spot before placing burning paper towel)...close the door and it will take a few minutes for the burning area to fully get going and give off a full burn. Make sure you have the correct stove pipe if going through the roof ..or wall...as this stove gives off intense heat and any pipe touching any wood or anything would eventually catch on fire.I put a metal pipe thru the wall then inserted a the stove pipe thru it as to insulate the stove pipe inside a tunnel away from wood or insulation.

Adjust the heat setting per size of area your heating, which if a small area it'll run and heat very well on just above low or between med and low