How do you bleed and adjust a series v rx7 hydraulic clutch?

Exactly like bleeding the brakes...

Behind the motor on the drivers side, towards the center of the firewall, you will see a shrader valve (Bleeder) for your clutch. Have another person with you for this.

Have the friend or whoever sit in the drivers seat and you at the bleeder and do the following.

1. Pump the clutch about 6 times and hold (do not release clutch yet)

2. Un-screw the bleeder(DO NOT TAKE IT OFF!!!, JUST UNSCREW ENOUGH UNTIL YOU SEE FLUID COME OUT). Then tighten it back.

NOTE: While bleeding, check the clutch slave cylinder because if that becomes empty, you will have air enter the system fast. so have a large bottle to flush/bleed system.

Repeat step 1 and 2, 3-5 times because you need to make sure you not only flush the system, but get rid of all the air from the system. if you don't then you will be able to shift while driving, then mysteriously you can't get the clutch in unless you "pump the clutch" a million times before you are able to disengage the clutch.

If you know how to bleed brakes, it's EXACTLY THE SAME.