How do you test the thermostat of your kwikot geyser?

Tools required: screw drivers, insulation tape - switch off your geaser, and plug out the power cable from the socket/power supply. Please also close the inlet water entry into your geaser. - remove the outer side of the geyser where the electrical connections are wired. This will need screwdrivers for most of the commercial geysers - Now you will see a big knob with temperature markings (usually 0 - 80 degree celsius) coming out of your geaser tank. - slowly track the electrical connections that is going into the thermostat and disconnect them (usually 2 of them) - Now pull the thermostat out - you will see a long rod coming out from the geaser. Now you are successful in pulling your thermostat out. - Now you want me to reverse-repeat the setps for plugging in the new thermostat in ? :-) - BTW...please note to set the temperature mark in the thermostat appropriately. Usually use the same as it was there in your older thermostat. - after plugging in the new thermostat, and you connect the electrical wiring, close the geyser (with whatever you removed) and open the inlet water entry. You need to plugin the power cable and switch it on again. Hope you find this useful, the new thermostat makes the geyser happy ! cheers, Harish