How do you remove the ignition switch in a Honda Nighthawk motorcycle?

Start by removing the front of the headlight (inside light will be full of wire connectors you'll have to disconnect these connectors in order to get lamp assembly out of the way).

With the headlamp either pushed aside or taken off completely remove the bolts holding the tack/speedo assembly. Then unscrew speedo cable from unit.

Now the unit is loose leave it where it is and find the bolts holding the fuse box.( These are a little tough to get off-careful).

Now with the fuse box loose take the bolts off the back of the ignition switch and slide her down (you might have to move the brake line around to get the right angle)

Good Luck