How do you change a clutch master cylinder in a Mitsubishi 3000 gt?

Under the hood - drain or soak up the brake fluid in the reservoir, remove 4 nuts/bolts to pull the A/C hose out of the way (tie it off), remove the plastic reservoir, disconnect the fluid line from the master cylinder (m/c). From inside the car - pull the pin that connects the rod to the clutch pedal, remove the 2 nuts that are holding the master cyl in place. Manipulate the m/c and rod and pull it out toward the engine compartment - it may require some force. If you rebuild it, make sure you hone it out and clean before assy. Try to adj the rod the same for fine tuning later - it will make it easier. Reverse for installation.